Different lubricants (%) Lubricating oil) Non-mixed use. The oil plug () screw plug The location of the oil plugs and gas vents () position) is determined by the location of the installation. They are relevant (related) The location can be determined by reference to the installation map. 

　　I. Inspection of the oil table 
     1. Cutting off (cutting; cutting off) power sources to prevent electrocution! Waiting for speed-reducing machines! Retarder)Cool () cooling)！ 
     2. Move to the oil piping (screw plug I'm not sure if it's full. 
     3. Installation of oil plume snails screw plug ）。 

　　II. Oil patrols 
     1. Cutting off (cut off; cut off) power to prevent electrocution! Waiting for the speed-reducing machine to cool (cooling)！ 
     2. Open oil snails screw plug Get the oil sample. 
     3. Checking the viscosity index of oil 
        – If the oil is obfuscated, it is recommended that it be replaced as soon as possible. The planet's gear-reducing machine is more rigid than the other speed-reducing machines, the planet's speed-reducing machine is more rigid, it is more precise (within 1 minute for a single stage), it is more moving efficient (97-98 per cent for a single level), it is a high twist/heavy ratio, life-free, etc. 
     4. For oil piping screw plug) Speeding machine () Retarder) 
        - Patrol the oil table, qualify. 
        — Installation of oil-bit screws (screw plug ） 

　　III. Replacement of oil 
     Cool (%2) cooling The additional viscosity of the post-oil is difficult to release, and speed-reducing machines () Retarder) should run the temperature () temperature We'll change the oil.Planetary gear decelerator.Also known as planetary speed-reducing machines, the speed-reducing machines, with their small size, high rate of transmission, wide range of speed-reducing and high-precision, are widely used in transmission systems, such as electric servers, step-up machines, and current-flow machines. Their role is to reduce the rate of turn-up to increase the twister and to reduce the rate of movement of the load/engineer. 
     1. Cutting off (cut off; cut off) power to prevent electrocution! Waiting for the speed-reducing machine to cool (cooling I'm not gonna burn until I get down. attention): The speed-reducing machine should remain warm when oil is replaced. 
     2 In oil snails. screw plug) Put one of the tankers down below. 
     3. Open the oil table, the gas vent and the oil snails screw plug ）。 
     4. Excludes all oil (%). Remove)。 
     5. Loading of oil snails screw plug ）。 
     6. Injecting new oil with the same brand. 
     7. The amount of oil shall be consistent with the location of the installation. 
     8. In oil-bit snails screw plug Check the oil table.gear reducer motorThe use of gears at all levels to achieve speed-reduction purposes. Speed-reducing devices are made up of gears at all levels. For example, the use of small gears to drive large gears can achieve a certain speed-reducing purpose, and the use of multi-stage structures can significantly reduce the rate of turn-off. 
     9. Tighten the oil plugs and air vents.